Magyar
English
AIJGO-22LCD Personal grounding tester
The AIJGO-22LCD is an easy-to-use tester for checking personal grounding before entering an ESD protected area (EPA). High load-bearing construction, it may be a good choice if speed and security are important factors due to the large number of entrances. Tester with LIGHT BAR system – such AIJGO products have a steel touch button, the measured results are indicated by LED lights.
The tester is supplied with manufacturer’s certificate, dual foot electrode, mounting plate and universal holder.
AIJGO-22LCD PERSONAL GROUNDING TESTER
WITH LCD DISPLAY AND DUAL FOOT ELECTRODE
| ABOUT THE PRODUCT |
- Tester for checking personal grounding before entering an ESD protected area (EPA)
- Testing footwear system and wrist strap/groundable ESD smock system at the same time
- Can be used to test a groundable ESD smock system
- Test result indication on LCD display, with LED light and sound
- Selectable test modes: Footwear sytem test only, or footwear system and wrist strap/groundable ESD smock system combined test
- We declare that the AIJGO-22LCD product complies with the requirements of IEC 61340-5-1, ANSI/ESD S20.20 and Directive 2001/95/EC (General product safety).
- For indoor use only
The AIJGO-22LCD is an easy-to-use tester for checking personal grounding before entering an ESD protected area (EPA). High load-bearing construction, it may be a good choice if speed and security are important factors due to the large number of entrances. Tester with LIGHT BAR system – such AIJGO products have a steel touch button, the measured results are indicated by LED lights. The type of test can be changed according to the entrance regulations: only footwear system test or the combined test of the footwear system and wrist strap/groundable ESD smock system. Thanks to the dual foot electrode, the tester simultaneously measures the resistance of the right and left foot relative to the hand. After the test, the measured values are displayed on the built-in LCD display. The tester can be connected to a gate using the relay output (e.g. to a turnstile entrance gate, swing gate, etc.). It can be installed on an entrance gate, table, wall or stand.
The tester is supplied with manufacturer’s certificate, dual foot electrode, mounting plate and universal holder.
CE declaration
We declare that the AIJGO-22LCD product complies with the requirements of IEC 61340-5-1, ANSI/ESD S20.20 and Directive 2001/95/EC (General product safety).
Warning
The device can deliver an effective output power of up to 20 µA or less at a maximum voltage of 100 V for 2-4 seconds at 0,5 second cycles. Therefore, persons with an implanted electronic device (e.g. insulin pump, pacemaker, etc.), known or acute hear rhythm disorders and other disorders of the heart’s impulse generation and conduction, seizure disorders (e.g. epilepsy) should consult their doctor before using this device.
| TECHNICAL INFORMATIONS |
Resistance values indicated as acceptable by the tester
| Default setting when measuring footwear system | 100 KΩ – 100 MΩ An upper value of 35 MΩ can be set using the red switch at the bottom of the tester. However, after setting a different limit from the one used previously, the device must be restarted for the change to take effect. |
| Default setting when measuring wrist strap/ groundable ESD smock system |
750 KΩ – 35 MΩ |
| Test voltage | 100V DC |
| Wrist strap/groundable ESD smock system connection | With a combined 10 mm snap, 4 mm banana plug socket |
| Power supply | 12 V DC |
| Relay outputs | 0,5 A/60 V Pass relay (Normally Open) with green wire Fail relay (Normally Open) with red wire |
| Sizes | 215 x 195 x 55 mm (tester) 500 x 630 x 970 mm (tester+stand with dual foot electrode, assembled), the touch button emerges from it beyond this, the tester extends 14 cm backwards beyond the platform. The size of the platform itself (for tester version with stand): 500 x 490 x 20 mm. Tilt angle of the stand: 5 degrees |
Mounting plate sizes
| REQUEST FOR QUOTATION |
| ORDER CODE | TYPE | |
|---|---|---|
| AIJGO-22LCD | Personal grounding tester with LCD display, dual foot electrode, mounting plate and universal holder | {AIJGO-22LCD} |
| AIJGO-STA | Stand for AIJGO tester | {AIJGO-STA} |
